Brady PAM 3000 Especificações descarregar pdf (Página 18)

18 Printer-Applicator-System PAM 3000

Operation

Special Settings for the Operation

There are four DIP-switches to determine several types of operation. The DIP-switches

are located at the right side of the printer.

Positioning of the Labels

The labels could be applied parallel to the print line (0°-position) as well as across to the

print line (90°-position). An external signal via PLC interface triggers the type of

labelling (see appendix C of the Operators Manual). The take-over of the labels is

carried out in the 0°-position for both types of applying. The procedure of the following

movements is different.

DIP-switch Parameter ON OFF

1 Label format small large

2 Recycle part not installed installed

3 Applicator installed not installed

4 Print repeat no yes

DIP-switch 1 - This switch is set on "ON" when small labels are used. By using large

labels the switch has to set on "OFF".

DIP-switch 2 - If the switch is set on "ON" it is not possible to dispose the bad labels

recognized by a scanner at a recycle part.

If the switch is set on "OFF" it is possible to apply the bad labels on the

recycle part.

It is recommended to set the switch always on "ON" if no scanner is

used.

DIP-switch 3 - If the switch is set on "ON" the printer notices that there is an applicator

to carry out the further steps after printing.

If the switch is set on "OFF" it is necessary to guarantee the correct

further processing of the applying process by other features for

example manually or by industrial robots.

DIP-switch 4 - If the switch is set on "ON" a bad label recognized by a scanner will not

printed again.

If the switch is set on "OFF" the print of a bad label recognized by a

scanner will be repeated.

It is recommended to set the switch always on "ON" if no scanner is

used.

1 2 ... 13 14 15 16 17 18 19 20 21 22

Sem comentários

Brady PAM 3000 Especificações Página 18