Brady Wraptor Guia do Utilizador Página 64
- Página / 72
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
7.2 Lubrication
Some Wraptor parts will need occasional lubrication in order to keep the unit running smoothly. It is
recommended that you check the following items for proper lubrication every 6 months to one year.
NOTE: Do not over-lubricate any of the parts. Make sure
to wipe off any excess oil or grease.
NOTE: The following procedures require that you
remove the label material and/or ribbon prior to
performing the maintenance. Remember to reload
material before attempting to print/wrap labels.
7.2.1 Oiling the Slide Track
The slide track carries the printer back and forth. Although it comes pre-oiled, you should inspect it and re-
oil as needed.
1. Press the Load Labels button on the Setup tab menu. This shuttles the printer to the “shuttle-back”
position.
2. Power off and unplug the Wraptor.
WARNING: You must power off and unplug the Wraptor
prior to performing any cleaning or maintenance!
3. Open the side door on the Wraptor.
4. Remove the ribbon.
5. Inspect the two oilers (shown below) on the outside of the slide track.
6. If dry, add a few drops of light machine oil.
NOTE: There are four oilers. Two are on the outside of
the slide track (shown below), and two are located
opposite these on the inside of the slide track.
Oilers
(Outside)
Figure 39. Oil Slide Track
7. Inspect the two oilers on the inside of the slide track: To access the inside oilers:
Manually shuttle the slide track back until the access hole (on the bottom of the track) is aligned
with the front/inside oiler.
Wraptor™ User’s Guide 57
- User’s Guide 1
- Copyright 2
- Regulatory Information 3
- Brady Warranty 3
- Wraptor™ User’s Guide III 4
- Table of Contents 5
- Table of Figures 7
- Chapter 1 Introduction 8
- 1.4 Technical Specifications 9
- Wraptor™ User’s Guide 3 10
- Chapter 2 Safety 11
- 2.2 Electrical Safety 12
- 2.3 Warning Labels 12
- 3.1 External Parts 13
- Wraptor™ User’s Guide 7 14
- 4.1 Initial Setup 15
- 10 Wraptor™ User’s Guide 17
- Wraptor™ User’s Guide 11 18
- 12 Wraptor™ User’s Guide 19
- Wraptor™ User’s Guide 13 20
- IP Address Option 21
- 14 Wraptor™ User’s Guide 21
- Printer Name Option 22
- Wraptor™ User’s Guide 15 22
- 16 Wraptor™ User’s Guide 23
- 4.2 Load Label Material 24
- 18 Wraptor™ User’s Guide 25
- Wraptor™ User’s Guide 19 26
- 20 Wraptor™ User’s Guide 27
- Wraptor™ User’s Guide 21 28
- 22 Wraptor™ User’s Guide 29
- 4.3 Load the Printer Ribbon 30
- 24 Wraptor™ User’s Guide 31
- Wraptor™ User’s Guide 25 32
- 26 Wraptor™ User’s Guide 33
- Adjustment for Wire Bundles 34
- Wraptor™ User’s Guide 27 34
- 5.2 Using the Touch Screen 35
- Figure 12. File Tab Menu 36
- Wraptor™ User’s Guide 29 36
- Open Command 37
- 30 Wraptor™ User’s Guide 37
- 5.3.2 Run Tab Commands 38
- Figure 15. Goto… Dialog 39
- 32 Wraptor™ User’s Guide 39
- Figure 16. Setup Tab Menu 40
- Wraptor™ User’s Guide 33 40
- Figure 17. Adj Tab Menu 41
- 34 Wraptor™ User’s Guide 41
- Advanced Settings Menu 42
- Advanced Settings Commands 42
- Wraptor™ User’s Guide 35 42
- Figure 20. Config Tab Menu 43
- Connection Type 43
- Operating Modes 43
- 36 Wraptor™ User’s Guide 43
- File Location 44
- Remote Control 44
- Figure 21. IP Tab Menu 44
- Wraptor™ User’s Guide 37 44
- Entering Text 45
- 38 Wraptor™ User’s Guide 45
- Description of Settings 46
- Wraptor™ User’s Guide 39 46
- 40 Wraptor™ User’s Guide 47
- Wraptor™ User’s Guide 41 48
- 42 Wraptor™ User’s Guide 49
- 5.5 Power Off 50
- 44 Wraptor™ User’s Guide 51
- Wraptor™ User’s Guide 45 52
- 46 Wraptor™ User’s Guide 53
- Wraptor™ User’s Guide 47 54
- 48 Wraptor™ User’s Guide 55
- Wraptor™ User’s Guide 49 56
- Chapter 7 Maintenance 57
- Wraptor™ User’s Guide 51 58
- Figure 33. Clean Printhead 59
- 52 Wraptor™ User’s Guide 59
- Figure 34. Clean Rollers 60
- Wraptor™ User’s Guide 53 60
- Figure 35. Clean V-Rollers 61
- 54 Wraptor™ User’s Guide 61
- Wraptor™ User’s Guide 55 62
- 6. Close the unit doors 63
- 7.2 Lubrication 64
- 58 Wraptor™ User’s Guide 65
- Wraptor™ User’s Guide 59 66
- 60 Wraptor™ User’s Guide 67
- Chapter 8 Error Messages 68
- 62 Wraptor™ User’s Guide 69
- Wraptor™ User’s Guide 63 70
- 64 Wraptor™ User’s Guide 71
- 9.1 Consumable material 72
- 9.2 Accessories 72
Manuais e produtos relacionados com Impressoras de rótulos Brady Wraptor
Impressoras de rótulos Brady IDXpert Handheld Labeler Keyboard Layout Manual do Utilizador
(4 páginas)
(4 páginas)
(84 páginas)
Impressoras de rótulos Brady 200M-e 300 Especificações
(118 páginas)
(118 páginas)
Impressoras de rótulos Brady 1024 Guia do Utilizador
(55 páginas)
(55 páginas)
Impressoras de rótulos Brady 2024 Guia do Utilizador
(89 páginas)
(89 páginas)
Impressoras de rótulos Brady 260M Guia do Utilizador
(104 páginas)
(104 páginas)
Impressoras de rótulos Brady POWERMark Especificações
(128 páginas)
(128 páginas)
Impressoras de rótulos Brady 1024 Manual do Operador
(82 páginas)
(82 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.046 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais