Brady THT-BP Precision Manual do Operador descarregar pdf (Página 120)

E-2 Transfer Printer THT-BP Precision

Fig. E-2 Changing Printhead (I)

1. Remove the media from the printer.

2. Swing the lever (6) to the position shown in figure E-2. In this position, the

printhead assembly is unlocked but still lying on the print roller.

3. Loosen the printhead locking screw (5) using the Allen key (7).

4. To lift the printhead assembly, swing the lever (6) clockwise until it stops.

5. Remove the printhead (1) from the pins (11) on the printhead carriage.

WARNING !

Unplug the power cord from the power source before starting!

CAUTION !

Protect the printhead against damage by electrostatic dischargement !

- Put the printer on to a grounded conductive surface !

- Ground yourself during printhead replacement for example using a

grounded wrist-strap !

- Do not touch the connector pins of the printhead by naked hands !

Make sure the glass surface on the printhead is not touched by sharp

objects or your hand!

Appendix E - Replacing Assembly Units

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 131 132

Sem comentários

Brady THT-BP Precision Manual do Operador Página 120